This
isn’t anything fancy like lipo’s or LED’s, but simple lock removal. Sometimes, it makes your blaster easier to
use. (Example: Stryfe pressure plates
should always be removed.)
DISCLAIMER: I AM NOT RESPONSIBLE FOR ANY
DAMAGE THAT MAY COME TO YOUR NERF GUN WHILE FOLLOWING THIS MOD GUIDE.
Supplies:
-
Philips Head Screwdriver and/or Philips Head
Drill
-
Duct Tape or Electrical Tape
First,
you have to open up your Rayven:
(picture 2)
Remove the screws shown and then remove the top orange plate
to get this: (Don’t lose the screws or
the orange plate)
(Picture 3)
Red Outlined Parts:
-
Remove these two parts of the lock. The sensor and the lock itself (Picture
below)
Green Outlined Parts:
-
Keep the mag release lever and the spring.
(picture 4)
(Picture of the sensor [right] and the lock [left]
After your remove these parts, move onto the other plate.
(picture 5)
Red Outlined Part:
-
Remove this plate
Yellow Outlined Part:
-
Carefully tape down the lock using the Duct or
Electrical Tape
(picture 6)
Yellow Outlined Part:
-
Carefully tape down the lock using the Duct or
Electrical Tape
(picture 7)
Red Outlined Part:
-
CAREFULLY
unscrew the screw in the red box and take off the rubber darts skirt. BE CAREFUL that you don’t break the
wires. I again Repeat the Disclaimer: I
am NOT responsible for anything that
may happen to your gun while following this mod guide.
-
You will have to do this on both sides of the
flywheel cage to fully remove the rubber dart skirt.
You will in the end
throw away these four parts:
1. The Rubber Dart Skirt (Picture 7)
2. The Orange Switch Plate (Picture 5)
3. The Sensor and the lock that goes with it.
(Picture 4)
