N-strike
Switchshot EX-1 Mod Guide/Overview
Please look at the video. At 00:00:55 I explain
what mods I did, and finish at 00:01:29.
The Basic tools required are:
- Philips head screwdriver (One that fits the
screws and fits down the holes)
- Electrical Tape (A ¼ of an inch piece)
- Scissors to cut a small bit of electrical tape.
- Needle-Nose Pliers (Or drill and a 12 inch drill bit of you are a pro)
- Needle-Nose Pliers (Or drill and a 12 inch drill bit of you are a pro)
Basics of the mod:
1.
Open up ONLY THE TOP PORTION (The part that can
be swapped with a Wii Remote)
2.
Unscrew all 4 screws and open the blaster
3.
Separate the barrel, and AR housing from the
plunger tube.
4.
Discard the AR and rip off the dart post. You can hollow out the dart post platform as
well, and make it look like the switch shot in the video.
5.
Put everything back together and close up the
blaster.
Please view the whole video
below, where I go over the steps above and take it a step further.
Remember, I am NOT, I repeat NOT, responsible for anything that
may happen to your nerf gun, while following my mod guide.
I hope you enjoy the mod guide,
and if you wish to contact with other ideas or have comments, please comment
below.
Sincerely,
The Nerf CommenTATER