N-strike Switchshot EX-1 Mod Guide/Overview

N-strike Switchshot EX-1 Mod Guide/Overview

                Please look at the video.  At 00:00:55 I explain what mods I did, and finish at 00:01:29.

               

The Basic tools required are:

    -   Philips head screwdriver (One that fits the screws and fits down the holes)

    -   Electrical Tape (A ¼ of an inch piece)

    -   Scissors to cut a small bit of electrical tape.
    -  Needle-Nose Pliers (Or drill and a 12 inch drill bit of you are a pro)

Basics of the mod:

1.       Open up ONLY THE TOP PORTION (The part that can be swapped with a Wii Remote)

2.       Unscrew all 4 screws and open the blaster

3.       Separate the barrel, and AR housing from the plunger tube.

4.       Discard the AR and rip off the dart post.  You can hollow out the dart post platform as well, and make it look like the switch shot in the video.

5.       Put everything back together and close up the blaster.

Please view the whole video below, where I go over the steps above and take it a step further.

Remember, I am NOT, I repeat NOT, responsible for anything that may happen to your nerf gun, while following my mod guide.

I hope you enjoy the mod guide, and if you wish to contact with other ideas or have comments, please comment below.

Sincerely,

The Nerf CommenTATER